Installation manual

SW3300-1
SW3300-2
SW3300-3
SW3300-4
SW3300-5
SW3300-5
SW3300-6
SW3300-7
SW3300-8
On
Off
Off
Off
Off
On
Off
Off
Off
Selects board 0
Selects board 1
Selects board 2
Selects board 3
P2 Bus not enabled
P2 Bus enabled - required if GP2 is installed
No connection
No connection
No connection
Jumper Settings
JUMPER PINS SETTING DESCRIPTION
J600 1-2
3-4
5-6
7-8
In
Out
Out
Out
V reset
External vertical blank output to ground
External display buffer A output to
No connection
J601 1-2
3-4
5-6
7-8
In
Out
Out
In
Green sync
Green sync
Sync
Sync
Notes
The Sun 4300 CPU must be 501-1316-03 for use with CG5.1.
The CG5 must be 501-1267-05 for use with the 501-1539 ISP-80 Disk Controller.2.
References
Installation Notes for the GP2 and CG5 Boards, 800-2330.1.
Configuration Procedures for the GP2 and CG5 Boards, 813-2059.2.
Last updated: December 2, 1996
Comments and Suggestions
Sun4/I: Graphics - CG5 Color Frame Buffer
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd00551.htm (3 von 3) [25.04.2002 16:20:21]