Installation manual

Table Of Contents
Jumper and Switch Settings
JUMPER SETTING DESCRIPTION
J1 Out Ground test point
J2 Out Ground test point
J3 Out Manual reset test point
J4 (2-3) In Graphics buffer = 2MB
J5 In/Out* Refresh interval test point bit 0
J6 In/Out* Refresh interval test point bit 1
J7 In/Out* Refresh interval test point bit 2
J8 In/Out* Refresh interval test point bit 2
J9 Out Ground test point
J10 Out Ground test point
*Hardwired
Notes
The Sun-2/160 Power Supply requires RC Network, 540-1300-01,
(FCO 160-0002, Doc 807-0029).
Reference
Hardware Installation Manual for the Sun-2/130 and Sun-2/160, 800-1144.
Last updated: December 2, 1996
Comments and Suggestions
Sun4/I: Graphics - GP Graphics Buffer
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd0054f.htm (2 von 2) [25.04.2002 16:20:08]