Installation manual

Jumper and Switch Settings
JUMPER SETTING DESCRIPTION
J1 Out GP board ID bit 3
J2 In GP board ID bit 4
J3 In GP board ID bit 2
J4 Out GP board ID bit 5
J5 Out GP board ID bit 1
J6 Out GP board ID bit 6
J7 In if GB is installed GP board ID bit 0
J8 Out GP board ID bit 7
J9 Out* Ground test point
J10 Out* Ground test point
J11 Out* PP halt test point
J12 Out* VP halt test point
J13 Out* Manual reset test point
J14 In Main clock connect
J15 Out VP free-running CLK test point
J16 Out PP free-running CLK test point
J17 Out* Ground test point
J18 Out Ground test point
*Hardwired
DIP SWITCH SETTING DESCRIPTION
UR11-1 On VME address bit 17
UR11-2 Off VME address bit 16
UR11-3 On VME address bit 23
UR11-4 On VME address bit 22
UR11-5 Off VME address bit 21
UR11-6 On VME address bit 20
UR11-7 On VME address bit 19
UR11-8 On VME address bit 18
Notes
The Sun-2/160 Power Supply requires RC Network 540-1300-01.1.
The default base address is 0x210000.2.
Reference
Graphics Processor Plus Configuration Procedures, 813-2023.
Sun4/I: Graphics - GP+ Graphics Processor Plus
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd0054e.htm (2 von 3) [25.04.2002 16:20:02]