Installation manual

1
2
3
4
Open
Closed
Open
Closed
Drive starts when DC Power is applied
Disable Port B
Enable Port A
Disable internal diagnostics
5
6
7
8
Open
Closed
Open
Closed
1D 3
1D 2
1D 1
1D 0
ID Microcode. Do Not Change
"
"
"
9 Open Slave/Master spindle sync-slave
Notes
Use terminator 370-1220-01 on the Port A/B Out connector.1.
Disable an unused port with the Port Enable/Disable switch.2.
Do not install a terminator on an unused port.3.
Switch 9 is on I/O board LYBX. It is not on I/O board BXDX.4.
Do not install Disk Drive 370-1187 in the Sun Expansion Pedestal if
there are cooling vents on the top cover.
5.
Power Supply 300-1052-02 does not support 1.2GB Disk Drives.6.
Power Supply 300-1052-03 supports two 1.2GB Disk Drives. Power
must be distributed between the two 410 Watt modules.
7.
Power Supply 300-1052-04 supports four 1.2GB Disk Drives.8.
Power Supply 300-1052-05 does not support 1.2GB Disk Drives.9.
Use Power Supply 300-1075 in the Sun Expansion Pedestal.10.
References
IPI8-1000/2HP Disk Drive Configuration and Installation Procedures
or the Sun Expansion Pedestal, 813-5377-11.
1.
IPI8-1000 and IPI8-1000/2HP Disk Drive Configuration and
Installation Procedures for the Sun 56-inch Cabinets, 813-1109-10.
2.
Last updated: December 2, 1996
Comments and Suggestions
Sun4/I: IPI - Seagate 97209-12G (1.2GB)
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd0057b.htm (4 von 4) [25.04.2002 16:19:36]