Installation manual

5
6
7
8
Open
Closed
Open
Closed
1D 3
1D 2
1D 1
1D 0
ID Microcode. Do Not Change
"
"
"
9 Open Slave/Master spindle sync-slave
Notes
The 911MB Disk requires minimum ISP-80 firmware 525-1023-05, 525-1024-07, and
525-1025-07.
1.
ISP-80 501-1539-05 and 501-1855-01 contain the minimum firmware required by the 911MB
Disk.
2.
Upgrade lower revision ISP-80 Controller boards with Option X2080A.3.
Use terminator 370-1220-01 on the Port A/B Out connector.4.
Disable an unused port with the Port Enable/Disable switch.5.
Do not install a terminator on an unused port.6.
There are cooling vents on the cover of 911MB Drive 370-1351. Do not install this drive in the
Sun Expansion Pedestal.
7.
There are no cooling vents on the cover of 911MB Drive 370-1352. Do not install this drive in
the Sun 56" Rack.
8.
Power Supply 300-1052 does not support the 911MB Drive.9.
Use Power Supply 300-1075 in the Sun Expansion Pedestal.10.
References
IPI8-1000/2HP Disk Drive Configuration and Installation Procedures for the Sun Expansion
Pedestal, 813-5377-11.
1.
PI8-1000 and IPI8-1000/2HP Disk Drive Configuration and Installation Procedures for the
Sun 56-inch Cabinets, 813-1109-10.
2.
Last updated: December 2, 1996
Comments and Suggestions
Sun4/I: IPI - Seagate 97229-11G (911MB)
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd0057a.htm (4 von 4) [25.04.2002 16:19:28]