Installation manual

Jumper JM2
PINS SETTING DESCRIPTION
1-2 In Enable UART clock
ISP-80 / IPI-2
A minimum ISP-80 firmware level is required to support these products.
PRODUCT U0501 U0502 U0503
911MB Disk 525-1023-05 525-1024-07 525-1025-07
Prestoserve 525-1023-05 525-1024-08 525-1025-08
1.3GB Disk 525-1023-05 525-1024-08 525-1025-08
Dual Port 525-1023-05 525-1024-09 525-1025-09
SNC 1.2 525-1023-05 525-1024-10 525-1025-10
These ISP-80 part numbers have the firmware level required for the products listed.
PRODUCT ISP-80 ISP-80
4400 CPU 501-1539-04 501-1855-01
911MB Disk 501-1539-05 501-1855-01
Prestoserve 501-1539-08 501-1855-02
1.3GB Disk 501-1539-09 501-1855-03
Dual Port 501-1539-09 501-1855-03
SNC 1.2 501-1539-10 501-1855-04
DP Bug fixes 501-1539-10 501-1855-04
Notes
Upgrade lower revision ISP-80 boards with firmware Option X2080A.1.
Do not install firmware Option X2080A on ISP-80 501-1539-06. An unused trace may cause a
system reset. Replace the ISP-80.
2.
Booting from an alternate controller (1, 2, 3, or 4) is not supported on the 4300 and 4400
systems. Refer to Bug ID 1027710.
3.
References
ISP-80 Disk Controller Configuration Procedures, 813-2065-10.1.
ISP-80 Disk Controller Installation and Configuration Procedures for the Sun 12-Slot Office
Pedestal, 813-1103-10.
2.
ISP-80 Disk Controller Installation and Configuration Procedures, 813-1050-11.3.
ISP-80 Disk Controller PROM Upgrade Manual, 813-6089-11.4.
Last updated: December 2, 1996
Sun4/I: IPI - ISP-80 / IPI-2
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd00579.htm (3 von 4) [25.04.2002 16:19:15]