Installation manual

When used with the Sun-4400 CPU, 501-1381, the board revision must be >=501-8027-07 or
the assembly must be >=501-1584-02.
3.
SCSI TERMPWR is provided on boards >=501-8027-07.4.
Reference
Sun SunNet Ethernet/VME Controller Configuration Procedures , 813-2082-10.
501-8027 Switch and Jumper Settings
DIP SWITCH SWITCH SETTING DESCRIPTION
SW0601 1-7 On Enable Thin Ethernet
1-7 Off Enable Ethernet*
DIP SWITCH SWITCH SETTING DESCRIPTION
SW0201 1 Off 24/32-bit addressing
2 Off/On N/C
3 * A18 address decode
4 * A19 address decode
5 * A20 address decode
6 Off A21 address decode
7 On A22 address decode
8 On A23 address decode
* DIP Switch SW0201 settings for ie2, ie3, and ie4
SW0201 SWITCH 3 SWITCH 4 SWITCH 5 ADDRESS
1st Board On On Off 31ff02
2nd Board Off On Off 35ff02
3rd Board Off Off On 2dff02
DIP SWITCH SWITCH SETTING DESCRIPTION
SW0202 1 On A24 address decode
2 On A25 address decode
3 On A26 address decode
4 On A27 address decode
5 On A28 address decode
6 On A29 address decode
7 On A30 address decode
JUMPER PINS SETTING DESCRIPTION
J0201 1-2 In Clock enable
J0601 1-2 In Level 1 Ethernet
J0601 1-2 Out Level 2 Ethernet
J0602 1-2 Out VCC to Pin-7 disabled
Sun4/I: SCSI - Sun-3/E SCSI/Ethernet
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd005d1.htm (2 von 3) [25.04.2002 16:19:05]