Installation manual

Table Of Contents
Switch and Jumper Settings
DIP
SWITCH
SETTING DESCRIPTION
1
2
3
Off*
Off
Off
SCSI BUS ADDRESS/TARGET
Bit 0-7
4 Off Not used
5 Off 512 byte/sector
6 Off Power on spin-up
7 Off Soft errors reported
8 Off Parity disabled
* For DeskTop Expansion Shoebox, Dip Switch 1 is ON for Target 1.
JUMPER SETTING DESCRIPTION
E, F* Out SCSI bus termination power option
* Jumpers E and F are not on Emulex Rev MD2110103.
Note
Install termination resistor packs on the last Tape/Disk Controller on the SCSI bus.
Reference
ESDI Disk Controller Configuration Procedures, 813-2022.
Last updated: December 2, 1996
Comments and Suggestions
Sun4/I: SCSI - Emulex MD21
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd005cd.htm (2 von 2) [25.04.2002 16:18:22]