Installation manual

SCO Out Spinup according to SD0 setting
SCP Out Parity enabled
SWP In Sweep cycle enabled
J01
JUMPER SETTING DESCRIPTION
1-2 The drive supplies TERMPWR to its own terminator.
It does not supply TERMPWR to the SCSI bus.
2-4 The drive supplies no TERMPWR.
The initiator supplies TERMPWR to the bus.
1-3
2-4
In
In
The drive supplies TERMPWR for the external
terminator at the end of the daisy chain. This
option is recommended only for the last drive
on a daisy chain.
Notes
The minimum operating system is SunOS 4.1.1.1.
SunOS 4.1.1 Sun-4c requires the 1.3GB Disk Drive Enhancement (esp.o, sd.o, and format.dat).2.
SunOS 4.1.1 Rev B Sun-4c requires the 1.3GB Disk Drive Enhancement (esp.o and sd.o).3.
SunOS 4.1.1 Sun-4 requires the 1.3GB Disk Drive Enhancement (format.dat).4.
Jumper J4A uses 2 mm shunts. Jumper J5 can be configured using 2.54 mm shunt 130-0272.
The Target ID is the Boolean OR of J4A and J5. Do NOT install shunts in both locations. Do
NOT install shunts at J4A when the address select switch cable is installed.
5.
The 1.3GB Disk Drive is not supported inside Sun 12-Slot Office Pedestals that use SCSI
Interface PCBs 501-1493 and 501-1496.
6.
The 1.3GB Disk Drive is not supported inside SCSI Peripheral Trays that use SCSI Interface
PCB 501-1496.
7.
References
Desktop Storage Module Service Manual, 800-6219-10.1.
Desktop Storage Module Service Manual, 800-7236-10.2.
Sun SCSI Expansion Pedestal Service Manual, 800-6402-11.3.
Sun SCSI Expansion Pedestal Service Manual, 800-7285-10.4.
12-Slot Office Pedestal with Single Peripheral Tray, 800-6497-10.5.
Last updated: December 2, 1996
Comments and Suggestions
Sun4/I: SCSI Disk - Seagate ST41600N (1.3GB)
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd005e1.htm (3 von 3) [25.04.2002 16:18:16]