Installation manual

In the Desktop Storage Module, orient Pin-1
of the Address Select Switch Cable with ID2
on J5. Remove all jumpers from J4A.
Power
2.4 Amps @ +5Vdc
2.1 Amps @ +12Vdc
37.2 Watts
Jumper Settings
Jumper J4A Jumper J5 Jumper J4B
J4A
JUMPER SETTING DESCRIPTION
ID0,ID1,ID 2 Out Drive ID select, Target 0
ID0 In Drive ID select, Target 1
ID1 In Drive ID select, Target 2
ID0,ID1 In Drive ID select, Target 3
WRT Out Write enabled
SLV Out Spindle sync master
J5*
JUMPER SETTING DESCRIPTION
ID0,ID1,ID 2 Out Drive ID select, Target 0
ID0 In Drive ID select, Target 1
ID1 In Drive ID select, Target 2
ID0,ID1 In Drive ID select, Target 3
* Factory configurations do not use shunts at Jumper J5.
J4B
JUMPER SETTING DESCRIPTION
SDO In Spinup Delay = 10sec x Target ID
Sun4/I: SCSI Disk - Seagate ST41600N (1.3GB)
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd005e1.htm (2 von 3) [25.04.2002 16:18:16]