Installation manual

Table Of Contents

J2 Auxiliary Connector with Adapter 811-1682-01

JUMPER SETTING DESCRIPTION

1,2,4 Out Target 0

1 In Target 1

2 In Target 2

1,2 In Target 3

JP35, JP36, and JP37

JUMPER SETTING DESCRIPTION

JP35, JP36, JP37 Out Target 0

JP35 In Target 1

JP36 In Target 2

JP35, JP36 In Target 3

Option Jumper Settings

JUMPER SETTING DESCRIPTION

JP14 In Spindle starts at power on

JP38 Out No motor delay at power on

JP40 In Enable parity detection

JP41 In Drive provides internal terminator power

JP34 Out Terminator power option

Notes

Drive address selection cannot be set on Auxiliary Connector J2 unless the adapter is installed.1.

The J2 Adapter must be installed in order for the ID Select Switch on the External Storage

Module to function

The Maxtor drive does not fit into the lower drive position of External Storage Modules

manufactured prior to October 1990. Remove the vertical stop block with 10-Inch End Cutter

250-1074-01.

References

5-1/4" SCSI Disk Drive Installation and Configuration for Sun Office Pedestals, 813-2048-11.1.

Revised Removal/Replacement Procedures for Sun ESM and EEM Storage Units, 814-3044-01.2.

Last updated: December 2, 1996

Comments and Suggestions

Sun4/I: SCSI Disk - Maxtor XT-8760S (669MB)

http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd005e0.htm (3 von 3) [25.04.2002 16:18:00]