Installation manual

Switch and Jumper Settings
DIP SWITCH SWITCH SETTING DESCRIPTION
SW1 1 Off Bit 0
2 Off Bit 1
3 On Bit 2-SCSI device address 04
4 Off Not used
5
6
On
Off
Archive Drive (Scorpion)
5
6
On
On
Wangtek Drive (5000E)
7 Off Drive type
8* Off SCSI bus parity check
* The Sun386i Tape assembly, 370-1179, includes the MT02 Controller and the Tape Drive. SW1,
Switch 8, is ON for this application.
JUMPER SETTING DESCRIPTION
A-B*
C-D*
In
Out
EPROM Memory size select
E-F*
In
Out
Hi/Lo write current (Archive Drive)
Hi/Lo write current (Wangtek Drive)
G-H
J-K **
L-M**
Out
Out
Out
* Jumpers A-B, C-D, and E-F are on the Emulex Rev. MW0210402 board. They are not on Rev.
MT0210403 and MT0210103 boards. SW1, Switch 5 and Switch 6, control drive selection on the
MT0210403 and MT0210203 boards.
**Jumpers J-K and L-M are in one of the locations shown on the board layout drawing.
Note
Terminators U5 and U46 must be installed for Sun-3/160 and Sun-3/180 Plus configurations.
Remove these terminators when the board is used with all other Sun-3 and Sun-4 Mass Storage
Subsystems.
References
Sun-3 Emulex MT02 Controller Configuration Procedures, 813-2011.1.
60 Mbyte Streaming Tape Drive with SCSI Controller Configuration Procedures, 814-1019.2.
Last updated: December 2, 1996
Sun4/I: Removable Media - Emulex MT02
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd005b1.htm (2 von 3) [25.04.2002 16:16:47]