Installation manual

ADDRESS BIT A15 A14 A13 A12 A11
Notes
SNC 1.2 requires Sun 4400 CPU 501-1381-09 or 501-1899-01.1.
SNC 1.2 requires IPI Firmware 525-1023-05, 525-1024-10, and 525-1025-10. This firmware is
installed on ISP-80 IPI Controller 501-1539-10 and 501-1855-04.
2.
SunOS for the Sun 4400 reserves 1 Megabyte of DVMA space for VME32 peripheral devices.
If the sum of DVMA space requested by VME32 devices is greater than 1 Megabyte, some
peripherals will not run correctly.
1 Network CoProcessor uses 192 Kilobytes of DVMA space
2 Network CoProcessors use 320 Kilobytes of DVMA space
3 Network CoProcessors use 320 Kilobytes of DVMA space
4 Network CoProcessors use 320 Kilobytes of DVMA space
5 Network CoProcessors use 400 Kilobytes of DVMA space
6 Network CoProcessors use 480 Kilobytes of DVMA space
3.
SunOS for the SPARCserver 600MP reserves 6 Megabytes of DVMA space for VME32
peripheral devices. If the sum of DVMA space requested by VME32 devices is greater than 6
Megabytes, some peripherals will not run correctly. Each Network CoProcessor uses 416
Kilobytes of DVMA space.
4.
Release Notes
SNC 1.0 supports the SS600MP on SunOS 4.1.2.1.
Patch 100639-01 supports the Sun 4400 on SunOS 4.1.2.2.
SNC 1.2 supports the Sun 4400 and SS600MP on SunOS 4.1.3.3.
The Sun Network CoProcessor is not supported in Solaris >=2.2.4.
References
Sun Network CoProcessor 1.0 Installation Manual, 800-6881-10.1.
Sun Network CoProcessor 1.2 Installation Manual, 800-6881-11.2.
Sun Network CoProcessor 1.2 Product Note, 801-5133-10.3.
Writing Device Drivers, 800-3851-10.4.
Last updated: December 2, 1996
Comments and Suggestions
Sun4/I: Communication - Sun Network CoProcessor
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd00520.htm (8 von 8) [25.04.2002 16:16:35]