Installation manual

36.0 Watts
Jumper and Switch Settings
JUMPER PINS SETTING DESCRIPTION
J0201 1-2 In Test jumper for oscillator
J0202 32 Bit In VME address bus size
J0202 24 Bit Out
J1501 RS-232 Out Not used for MCP
J1501 RS-449 In Enables RS-449 Port 0
J1502 RS-232 Out Not used for MCP
J1502 RS-449 In Enables RS-449 Port 1
J1503 1-2 In Test jumper for oscillator
DIP SWITCH S0201 DIP SWITCH S0202
ADDRESS BIT
A
1
6
A
1
7
A
1
8
A
1
9
A
2
0
A
2
1
A
2
2
A
2
3
A
2
4
A
2
5
A
2
6
A
2
7
A
2
8
A
2
9
A
3
0
A
3
1
SWITCH and SETTING 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
mcp0 @ 0x01000000 1 1 1 1 1 1 1 1 0 1 1 1 1 1 1 1
mcp1 @ 0x01010000 0 1 1 1 1 1 1 1 0 1 1 1 1 1 1 1
mcp2 @ 0x01020000 1 0 1 1 1 1 1 1 0 1 1 1 1 1 1 1
mcp3 @ 0x01030000 0 0 1 1 1 1 1 1 0 1 1 1 1 1 1 1
0 = Off
1 = On
Notes
The Sun-3/110 and Sun 3004 CPU must be 501-1134-06, 501-1163-09, 501-1164-09, or
greater. All 501-1208 and 501-1209 revisions are usable.
1.
The MCP is not supported in Solaris >=2.2.2.
An addressing conflict can occur between the MCP, ALM-1, and ALM-2. Refer to the VME
Installation Notes in the Slot Assignment chapter.
3.
Reference:
MCP Configuration Procedures, 813-2032.
Last updated: December 2, 1996
Comments and Suggestions
Sun4/I: Communication - Multiprotocol Communication Processor
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd0051c.htm (2 von 2) [25.04.2002 16:15:36]