Installation manual

Notes
Board revision 501-8027-06 or 501-1584-01 is required for use in any SPARC CPU based
system.
1.
When used with the Sun-4400 CPU, 501-1381, the board revision must be >=501-8027-07 or
the assembly must be >=501-1584-02.
2.
Switch and Jumper Settings
DIP SWITCH SWITCH SETTING DESCRIPTION
SW0601 1-7
1-7
On
Off
Not Supported
Enable Ethernet*
SW0201 1
2
3
4
5
6
7
8
Off
Off/On
*
*
*
Off
On
On
24/32-bit addressing
N/C
A18 address decode
A19 address decode
A20 address decode
A21 address decode
A22 address decode
A23 address decode
*DIP Switch SW0201 settings for ie2, ie3, and ie
SW0201 SWITCH 3 SWITCH 4 SWITCH 5 ADDRESS
1st Board On On Off 31ff02
2nd Board Off On Off 35ff02
3rd Board Off Off On 2dff02
DIP SWITCH SWITCH SETTING DESCRIPTION
SW0202 1 On A24 address decode
SW0202 2 On A25 address decode
SW0202 3 On A26 address decode
SW0202 4 On A27 address decode
SW0202 5 On A28 address decode
SW0202 6 On A29 address decode
SW0202 7 On A30 address decode
SW0202 8 On A31 address decode
JUMPER PINS SETTING DESCRIPTION
J0201 1-2 In Clock enable
J0601 1-2 In Level 1 Ethernet
J0601 1-2 Out Level 2 Ethernet
J0602 1-2 Out VCC to Pin-7 disabled
Sun4/I: Communication - Sun-3/E Ethernet Assembly
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00005/wcd00514.htm (2 von 3) [25.04.2002 16:14:38]