Installation manual

SPARCprinter Output Component Tests
Switch the printer OFF.1.
Press and hold ENTER.2.
Switch the printer ON.3.
Press TEST until the desired diagnostic test number is displayed in the Operator Panel. The
following output components can be tested:
Component Test Code
Print Counter 30
Upper Feed Clutch 80
Lower Feed Clutch 81
Registration Clutch 82
Upper Turn Roll Clutch 84
Lower Turn Roll Clutch 84
Main Motor & Erase Lamp 90
HVPS 90
4.
Press ENTER to test the component.5.
Switch the printer OFF to exit the Sensor Check Diagnostics.6.
SPARCprinter NVRAM Parameters
Switch the printer OFF.1.
Press and hold TEST and ENTER.2.
Switch the printer ON.3.
Release TEST.4.
Release ENTER when the display shows 03.5.
The NVRAM parameter and value are displayed.6.
Press ENTER to change a value.7.
Press TEST to store a new value.8.
Press TEST to display the next parameter.9.
Switch the printer OFF to exit the NVRAM Parameters.10.
Function Address Content
Processing Direction 0 xx
1
Scanning Direction 1 xx
2
IOT Test Print 2 NA
3
Fuser Temperature 3 xx
4
Laser Power 4 xx
4
Resolution 5 xx
4
Video Mode 6 xx
4
Sun4/II: Parts - Printer - SPARCprinter
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00006/wcd00677.htm (3 von 4) [25.04.2002 16:03:12]