Installation manual

SPARCprinter IOT Test Print
Switch the printer OFF.1.
Press and hold TEST.2.
Switch the printer ON.3.
Release TEST. 00 is displayed. The printer must warm-up for approximately one minute in
order to print a test page.
4.
Press ENTER to start printing the IOT test print. The display indicates the number of test pages
printed.
5.
Press ENTER to stop printing the IOT test print.6.
Switch the printer OFF to exit the IOT Test Print Mode.7.
Reference
SPARCprinter Service Guide, 800-5044-10.
SPARCprinter Input Component Tests
Switch the printer OFF.1.
Press and hold ENTER.2.
Switch the printer ON.3.
Release ENTER. The Operator Panel displays 02.4.
Press ENTER to select the Input Component Tests. The Operator Panel displays 00.5.
The following input components can be tested: Fuser Exit Sensor, Toner Cartridge Switch,
Paper Size Sensors, Drum Cartridge Switch, Paper Tray Empty Sensors, Manual Bypass
Feature Switch, Reset Switch, Interlock Switch, and Test Switch. The input component is
functional if the value displayed in the Operator Panel increases when the component is
activated.
6.
Switch the printer OFF to exit the Sensor Check Diagnostics7.
Sun4/II: Parts - Printer - SPARCprinter
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00006/wcd00677.htm (2 von 4) [25.04.2002 16:03:12]