Installation manual

3b 03 Tape or electronic vertical forms unit not ready
3b 04 Slew failure
3b 05 Paper jam
3b 06 Failed to sense top of form
3b 07 Failed to sense bottom of form
3b 08 Reposition error
3b 09 Read past end of medium
3b 0a Read past begining of medium
3b 0b Position past end of medium
3b 0c Position past begining of medium
3b 0d Medium destination element full
3b 0e Medium source element empty
3d 00 Invalid bits in identify message
3e 00 Logical unit has not self configured yet
3f 00 Target operating conditions have changed
3f 01 Microcode has been changed
3f 02 Changed operating definition
3f 03 Inquiry data has changed
40 nn Diagnostic failure on component nn (80h-ffh)
41 00 Data path failure
42 00 Power-On or Self-Test failure
43 00 Message error
44 00 Internal target failure
45 00 Select/Reselect failure
46 00 Unsuccessful soft reset
47 00 SCSI parity error
48 00 Initiator detected error message received
49 00 Invalid message error
4a 00 Command phase error
4b 00 Data phase error
4c 00 Logical unit failed self configuration
4e 00 Overlapped commands attempted
50 00 Write append error
50 01 Write append position error
50 02 Position error related to timing
51 00 Erase failure
52 00 Cartridge fault
53 00 Media load/eject failed
53 01 Unload tape failure
53 02 Medium removal prevented
54 00 SCSI to host system interface failure
Sun4/II: Trouble - Disk - SCSI Sense Codes
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00007/wcd0071d.htm (4 von 5) [25.04.2002 16:01:52]