Installation manual

1d 00 Miscompare during verify operation
1e 00 Recovered ID with ECC correction
20 00 Invalid command operation code
21 00 Logical block address out of range
21 01 Invalid element address
22 00 Illegal function for device type
24 00 Invalid field in CDB
25 00 Logical unit not supported
26 00 Invalid field in parameter list
26 01 Parameter not supported
26 02 Parameter value invalid
26 03 Threshold parameters not supported
27 00 Write protected
28 00 Not ready to ready transition
28 01 Import / Export element accessed
29 00 Power-On, reset, or bus device reset occurred
2a 00 Parameters changed
2a 01 Mode parameters changed
2a 02 Log parameters changed
2b 00 Copy cannot execute since host cannot disconnect
2c 00 Command sequence error
2c 01 Too many windows specified
2c 02 Invalid combination of windows specified
2d 00 Overwrite error on update in place
2f 00 Commands cleared by another initiator
30 00 Incompatible medium installed
30 01 Cannot read medium - unknown format
30 02 Cannot read medium - incompatible format
30 03 Cleaning cartridge installed
31 00 Medium format corrupted
31 01 Format command failure
32 00 No defect spare location available
32 01 Defect list update failure
33 00 Tape length error
36 00 Ribbon/Ink/Toner faliure
37 00 Rounded parameter
39 00 Saving parameters not supported
3a 00 Medium not present
3b 00 Sequential positioning error
3b 01 Tape position error at begining of medium
3b 02 Tape position error at end of medium
Sun4/II: Trouble - Disk - SCSI Sense Codes
http://lios.apana.org.au/~cdewick/sunshack/data/feh/1.4/wcd00007/wcd0071d.htm (3 von 5) [25.04.2002 16:01:52]