User manual

f. Remove the wireless antenna cables and transceivers (4).
The wireless antenna cables and transceivers are available using spare part number 924307-001.
Reverse this procedure to reassemble and install the display assembly.
Power connector cable
Description Spare part number
Power connector cable 933523-001
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 30), and then remove the following components:
a. Battery (see Battery on page 32)
b. System board (see System board on page 41)
c. Speakers (see Speakers on page 51)
d. Display assembly (see Display assembly on page 53)
Remove the power connector cable:
▲
Remove the power connector cable.
Component replacement procedures 61