User manual
4. Remove the bottom cover (see Bottom cover on page 30).
5. Remove the battery (see Battery on page 32).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.4 broad head screw (1) that secures the solid-state drive to
the system board.
2. Remove the solid-state drive (2) by pulling it away from the connector.
NOTE: Solid-state drives are designed with notches to prevent incorrect insertion.
Reverse this procedure to reassemble and install the solid-state drive.
Memory module
NOTE: Primary and expansion memory is installed in a side-by-side conguration on the system board. If
only one memory module is installed, it must be installed in the socket labeled 1.
Description Spare part number
8-MB, SODIMM, DDR4-2400, 1.2-V 862398-855
4-MB, SODIMM, DDR4-2400, 1.2-V 862397-855
Update BIOS before adding memory modules
Before adding new memory, make sure you update the computer to the latest BIOS.
CAUTION: Failure to update the computer to the latest BIOS prior to installing new memory may result in
various system problems.
To update BIOS:
1. Navigate to www.hp.com.
2. Click Support & Drivers, and then click Drivers & Software.
3. In the Enter a product name/number box, type the computer model information, and then click Search.
Component replacement procedures 35