User manual

3. If it is necessary to disassemble the hard drive, remove the hard drive rubber sleeve (1) from
the hard drive, and then disconnect the hard drive cable (2) from the hard drive.
Reverse this procedure to reassemble and install the hard drive.
Solid-state drive
Description Spare part number
For use only on computer models with model numbers 15m-bp1xx through 15-bp1xx:
512-GB, 2280, PCIe, NVMe solid-state drive L01301-002
256-GB, 2280, PCIe, NVMe solid-state drive L01300-002
For use on all computer models:
512-GB, 2280 M.2, PCIe3×4, SS, NVMe solid-state drive with TLC 847110-015
360-GB, 2280 M.2, PCIe3×4, SS, NVMe solid-state drive with TLC 917818-002
256-GB, 2280 M.2, PCIe3×4, SS, NVMe solid-state drive with TLC 847109-018
256-GB, 2280 M.2, SATA-3, with solid-state drive TLC 759848-028
128-GB, 2280 M.2, SATA-3 solid-state drive 827560-038
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
34 Chapter 5 Removal and replacement procedures