User Manual

Removing the display stand
You can remove the display head from the stand to install the panel on a wall, a swing arm, or other mounting
xture.
CAUTION: Before beginning to disassemble the display, be sure it is turned o and the power, signal, and
network cables are all disconnected. Also disconnect all USB cables connected to the display.
1. Disconnect and remove all cables from the display.
2. Lay the display facedown on a at surface covered by a clean, dry cloth.
3. Press down on the latch near the bottom center of the display to unlock the stand (1).
4. Swing the bottom of the stand up until the mounting plate clears the recess in the panel (2).
5. Slide the stand out of the recess (3).
16 Chapter 1 Getting Started