User Manual

3. Adjust the display’s height to a comfortable position for your individual workstation. The display’s top
bezel edge should not exceed a height that is parallel to your eye height. A display that is positioned low
and reclined may be more comfortable for users with corrective lenses. The display should be
repositioned as you adjust your working posture throughout the work day.
Turning on the display
1. Set the master power switch on the rear of the display to the On position.
2. Press the power button on the computer to turn it on.
3. Press the power button on the front of the display to turn it on.
NOTE: The rst time the display is turned on from the master power switch it may take up to 30 seconds
before the display responds to the front power button. This is normal and is due to the booting of internal
systems.
NOTE: If pressing the power button has no eect, the Power Button Lockout feature may be enabled. To
disable this feature, press and hold the display power button for 10 seconds.
When the display is powered on, a status message is displayed for ve seconds. The message shows which
input is the current active signal, the status of the auto-switch source setting (On or O; factory default is
On), the default source signal (factory default is DisplayPort), the current preset display resolution, and the
recommended preset display resolution.
The display automatically scans the signal inputs for an active input and uses that input for the display. If two
or more inputs are active, the display will indicate the default input source. If the default source is not one of
14 Chapter 1 Getting Started