User Manual

Table Of Contents
ITWW
Informazioni sulle normative di conformità 109
Informazioni sulle normative di conformità
La stampante soddisfa i requisiti degli enti normativi del proprio paese/regione.
Questo capitolo tratta i seguenti argomenti:
Numero di modello normativo
Specifica FCC
Istruzioni per il cavo di alimentazione
Avviso per gli utenti residenti in Corea
Dichiarazione sulle emissioni acustiche per la Germania
Avviso normativo per l'Unione Europea
Informazioni per gli utenti residenti in Germania
Dichiarazione di conformità
Normative wireless
Numero di modello normativo
Ai fini della conformità alle norme, al prodotto è assegnato un Numero di modello normativo. È importante
non confondere tale numero di modello normativo con il nome commerciale o con il numero del prodotto.
Specifica FCC
The United States Federal Communications Commission (in 47 CFR 15.105) has specified that the following
notice be brought to the attention of users of this product.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
NOTE: If the product has an Ethernet / LAN port with metallic casing then use of a shielded interface cable
is required to comply with the Class B limits of Part 15 of FCC rules.
Modifications (part 15.21)
Any changes or modifications made to this device that are not expressly approved by HP may void the user's
authority to operate the equipment.