- Hewlett-Packard IP Console Switch User Guide
Table Of Contents
- HP IP Console Switch User Guide
- Notice
- Contents
- About This Guide
- Chapter 1: Overview
- Chapter 2: Installing the IP Console Switch
- Chapter 3: Expansion Module
- Chapter 4: Interface Adapters
- Chapter 5: Cascade Console Switches
- Chapter 6: Local Port Operation
- Viewing and Selecting Ports and Servers
- Soft Switching
- Using Basic OSD Navigation
- Configuring the OSD Setup Menu
- Assigning Server Names
- Assigning Device Types
- Changing the Display Behavior
- Controlling the Status Flag
- Broadcasting to Servers
- Setting up a Scan Pattern
- Setting Local Console Switch Security
- Managing Server Tasks Using the OSD
- Viewing and Disconnecting User Connections
- Running System Diagnostics
- Resetting the PS/2 Mouse
- Displaying Version Information
- Chapter 7: Upgrading Firmware using TFTP
- Chapter 8: Troubleshooting
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Power Cord Set Requirements
- Index
Local Port Operation
6-14 HP IP Console Switch User Guide
HP CONFIDENTIAL
Writer: Amy L. Laffitte File Name: g-ch6 Local Port Operation.doc
Codename: Eagle Part Number: 263924-002 Last Saved On: 3/31/03 3:17 PM
Assigning Device Types
To assign a device type:
1. In the Devices dialog box, select the Port number.
2. Click Modify. The Device Modify dialog box is displayed.
3. Choose the number of ports supported by the cascaded console switch.
4. Click OK.
5. Repeat steps 2 through 4 for each port the user wants to assign a device type.
6. Click OK in the Devices dialog box to save settings.
NOTE: Changes made in the Device Modify dialog box are not saved until you click OK
in the Devices dialog box.
Figure 6-6: Device Modify dialog box