- Hewlett-Packard IP Console Switch User Guide
Table Of Contents
- HP IP Console Switch User Guide
- Notice
- Contents
- About This Guide
- Chapter 1: Overview
- Chapter 2: Installing the IP Console Switch
- Chapter 3: Expansion Module
- Chapter 4: Interface Adapters
- Chapter 5: Cascade Console Switches
- Chapter 6: Local Port Operation
- Viewing and Selecting Ports and Servers
- Soft Switching
- Using Basic OSD Navigation
- Configuring the OSD Setup Menu
- Assigning Server Names
- Assigning Device Types
- Changing the Display Behavior
- Controlling the Status Flag
- Broadcasting to Servers
- Setting up a Scan Pattern
- Setting Local Console Switch Security
- Managing Server Tasks Using the OSD
- Viewing and Disconnecting User Connections
- Running System Diagnostics
- Resetting the PS/2 Mouse
- Displaying Version Information
- Chapter 7: Upgrading Firmware using TFTP
- Chapter 8: Troubleshooting
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Power Cord Set Requirements
- Index
Expansion Module
HP IP Console Switch User Guide 3-7
HP CONFIDENTIAL
Writer: Amy L. Laffitte File Name: d-ch3 Expansion Module.doc
Codename: Eagle Part Number: 263924-002 Last Saved On: 3/18/03 10:13 AM
Performing a Velcro-Mount Installation
To Velcro mount an Expansion Module to the rack:
1. Determine the location for the Expansion Module.
2. Remove the protective strip (1) from the Velcro, and attach it to the Expansion
Module.
3. Remove the protective strip (1) from the other side of the Velcro, and attach it to
the rack frame (2).
2
1
1
Figure 3-6: Velcro-mounting the Expansion Module