- Hewlett-Packard IP Console Switch User Guide
Table Of Contents
- HP IP Console Switch User Guide
- Notice
- Contents
- About This Guide
- Chapter 1: Overview
- Chapter 2: Installing the IP Console Switch
- Chapter 3: Expansion Module
- Chapter 4: Interface Adapters
- Chapter 5: Cascade Console Switches
- Chapter 6: Local Port Operation
- Viewing and Selecting Ports and Servers
- Soft Switching
- Using Basic OSD Navigation
- Configuring the OSD Setup Menu
- Assigning Server Names
- Assigning Device Types
- Changing the Display Behavior
- Controlling the Status Flag
- Broadcasting to Servers
- Setting up a Scan Pattern
- Setting Local Console Switch Security
- Managing Server Tasks Using the OSD
- Viewing and Disconnecting User Connections
- Running System Diagnostics
- Resetting the PS/2 Mouse
- Displaying Version Information
- Chapter 7: Upgrading Firmware using TFTP
- Chapter 8: Troubleshooting
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Power Cord Set Requirements
- Index
Installing the IP Console Switch
2-12 HP IP Console Switch User Guide
HP CONFIDENTIAL
Writer: Amy L. Laffitte File Name: c-ch2 Installing.doc
Codename: Eagle Part Number: 263924-002 Last Saved On: 3/31/03 3:13 PM
5. Tighten the wing nuts slightly to stabilize the adjustable rails during installation.
6. Insert an adjustable rail into the rack, and hook the tabs into the appropriate holes
at the rear of the rack, aligning the screws holes at the front of the rack.
7. Secure the rear of the adjustable rail, using one screw for each cage nut
previously installed.
Figure 2-12: Securing the adjustable rail