- Hewlett-Packard IP Console Switch User Guide
Table Of Contents
- HP IP Console Switch User Guide
- Notice
- Contents
- About This Guide
- Chapter 1: Overview
- Chapter 2: Installing the IP Console Switch
- Chapter 3: Expansion Module
- Chapter 4: Interface Adapters
- Chapter 5: Cascade Console Switches
- Chapter 6: Local Port Operation
- Viewing and Selecting Ports and Servers
- Soft Switching
- Using Basic OSD Navigation
- Configuring the OSD Setup Menu
- Assigning Server Names
- Assigning Device Types
- Changing the Display Behavior
- Controlling the Status Flag
- Broadcasting to Servers
- Setting up a Scan Pattern
- Setting Local Console Switch Security
- Managing Server Tasks Using the OSD
- Viewing and Disconnecting User Connections
- Running System Diagnostics
- Resetting the PS/2 Mouse
- Displaying Version Information
- Chapter 7: Upgrading Firmware using TFTP
- Chapter 8: Troubleshooting
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Power Cord Set Requirements
- Index
Upgrading Firmware using TFTP
HP IP Console Switch User Guide 7-5
HP CONFIDENTIAL
Writer: Amy L. Laffitte File Name: h-ch7 TFTP Downloads.doc
Codename: Eagle Part Number: 263924-002 Last Saved On: 3/31/03 3:11 PM
2. You can use the default settings for the directory with the GET access or
PUT access rights set as indicated in the following procedure. To use the default
settings, select Use Default Settings, then click Exit.
To customize settings, select Customize Settings.
a. To add directories, click Add. The Secure TFTP Directory dialog box
is displayed.
b. Enter the path name of the directory, or click Browse, select a directory, and
then click OK.
c. To enable GET access or PUT access to that directory, select the GET
Access or the PUT Access checkbox.
d. Click OK. The added directory is displayed in the list.
Figure 7-2: Secure TFTP Directory dialog box