Instruction Manual

Table 2 Capacity for data in a hard disk drive associated with a CLPR and standard
cache capacity
Capacity for data in
CLPR
to 0.7TB to 2.6TB to 8.5TB
to 14.4TB
to 20.3TB 20.3TB or
more
Standard cache
capacity
4GB
8GB 12GB 16GB 20GB
24GB
NOTE:
To calculate t
he capacity for data in a hard disk drive associated with a CLPR, add the following
formulas:
Number of pari
ty groups: capacity of one disk x 3 x (3D+1P)
Number of parity groups: capacity of one disk x 6 x (6D+2P)
Number of parity groups: capacity of one disk x 7 x (7D+1P)
Number of par
ity groups: capacity of one disk x 2 x (2D+2D)
NOTE:
To add cache memories to the local array, install them with Standard Cache Access Model or High
Performance Cache Access Model mode. If the local array has additional printed circuit boards
(PCBs), you must use the High Performance Cache Access Model mode. For more information about
additional cache memories, contact your HP account support representative.
• RestrictiononCLPRand CU group
You cannot allocate parity groups belonging to different CU groups to a CLPR other than CLPR0.
For more information about CU groups, see the HP StorageWorks XP Remote Web Console user
guide for XP12000/XP10000/SVS200.
Storage ma
nagement logical partitions (SLPRs)
An array ca
n be shared with multiple organizations, for example, enterprises and departments within
an enterp
rise. Therefore, multiple administrators who belong to different organizations might manage
one array
. This creates the potential for an administrator who belongs in one organization to destroy
other or
ganizations' volumes. Furthermore, it can complicate and increase the difficulty of managing the
array be
cause of an incorrect operation by an administrator and its influence on other organizations.
The sto
rage management logical partition function in XP Disk/Cache Partition allocates all of an array's
resources (that is, ports and CLPRs) to multiple virtual arrays. Each virtual array can be accessed by only
its administrator. Therefore, this prevents the risk that an administrator will destroy another organization's
volume
s or leak another organization's data.
In a non
-partitioned environment, a full array is considered one single partition SLPR0. After the array is
parti
tioned, SLPR0 becomes the unpartitioned portion of the array. Similarly, CLPR0 contains all parity
groups (PGs) and cache in the non-partitioned environment. After the array is partitioned, CLPR0 contains
the remaining PGs and cache that are not allocated to other CLPRs.
Figure 2 shows an example of when one array is partitioned into two virtual arrays. Each virtual array is
alloc
ated to two enterprises respectively. In this case, enterprise A's array administrator can manage
ente
rprise A's virtual array, but cannot manage one of enterprise B's arrays. Similarly, enterprise B's array
admi
nistrator can manage enterprise B's virtual array, but cannot manage one of enterprise A's arrays.
IMPORTANT:
Disk/cache partitioning for the SVS200 is limited to one SLPR and four CLPRs.
HP StorageWorks
13