- HP Network Switch User Manual
Table Of Contents
- ProCurve Switch 1700-8 and 1700-24 Management and Configuration Guide
- Title Page
- Copyright and Disclaimer Notices
- Contents
- 1. Getting Started
- 2. Using the ProCurve Web Browser Interface
- Overview
- Navigating the Web Browser Interface
- Web Configuration
- Displaying System Information
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Rate Limits
- Port Configuration
- Port Mirroring
- Showing Port Statistics
- Trunk Membership
- Trunk Configuration
- LACP Settings
- LACP Status
- VLAN Setup
- VLAN Port Config
- LLDP Configuration
- LLDP Neighbor Table
- SNMP Configuration
- Ping Test
- Restore to Factory Defaults
- Reboot Switch
- Upload/Download Configuration
- Download Text Readable Configuration/Status File
- Update Software
- Support
- 3. Troubleshooting
- Index
- Back Cover
2-35
Using the ProCurve Web Browser Interface
Web Configuration
Using the ProCurve Web
Browser Interface
Reboot Switch
Reboots the switch if the switch stops responding or functioning. This
operation will not change any switch configuration settings. To reboot the
switch, click APPLY. The reboot will be complete when the user interface
displays the login page.
Web – Click Diagnostics, Reboot Switch.
Upload/Download Configuration
Upload or download the switch system configuration file. Click to select either
the “Upload” or “Download” box. If you click on “Upload”, then click on the
“Browse” button to select the configuration file. If you click on “Download”,
you will be prompted to save your file. Please enter a name for the
configuration file. Finally, press the APPLY button to upload or download the
configuration file.
Note After you have completely finished configuring the switch settings, it is
important to download the configuration file. You can use this saved
configuration file to restore the switch settings at a later point if the switch
settings have been changed or restored to the default settings.
Field Attributes
• Operation – To upload or download the configuration file.
• Configuration File – Click on the “Browse” button to select the
configuration file. (Only available for the upload operation.)