- HP Network Switch User Manual
Table Of Contents
- ProCurve Switch 1700-8 and 1700-24 Management and Configuration Guide
- Title Page
- Copyright and Disclaimer Notices
- Contents
- 1. Getting Started
- 2. Using the ProCurve Web Browser Interface
- Overview
- Navigating the Web Browser Interface
- Web Configuration
- Displaying System Information
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Rate Limits
- Port Configuration
- Port Mirroring
- Showing Port Statistics
- Trunk Membership
- Trunk Configuration
- LACP Settings
- LACP Status
- VLAN Setup
- VLAN Port Config
- LLDP Configuration
- LLDP Neighbor Table
- SNMP Configuration
- Ping Test
- Restore to Factory Defaults
- Reboot Switch
- Upload/Download Configuration
- Download Text Readable Configuration/Status File
- Update Software
- Support
- 3. Troubleshooting
- Index
- Back Cover
2-34
Using the ProCurve Web Browser Interface
Web Configuration
Using the ProCurve Web
Browser Interface
Restore to Factory Defaults
This operation allows you to either restore the switch back to the original
factory default configuration, or to clear all configuration information except
the IP Address, Subnet Mask and Gateway IP Address (see the SYSTEM > IP
Address page).
Field Attributes
• Restore Entire Factory Default Configuration – Restore the
switch to the original factory default configuration.
• Keep Current IP Address Only – Restore the switch to the original
factory default configuration, except for the IP Address, Subnet Mask
and Gateway IP Address.
Web – Click Diagnostics, Factory Defaults.