- HP Network Switch User Manual
Table Of Contents
- ProCurve Switch 1700-8 and 1700-24 Management and Configuration Guide
- Title Page
- Copyright and Disclaimer Notices
- Contents
- 1. Getting Started
- 2. Using the ProCurve Web Browser Interface
- Overview
- Navigating the Web Browser Interface
- Web Configuration
- Displaying System Information
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Rate Limits
- Port Configuration
- Port Mirroring
- Showing Port Statistics
- Trunk Membership
- Trunk Configuration
- LACP Settings
- LACP Status
- VLAN Setup
- VLAN Port Config
- LLDP Configuration
- LLDP Neighbor Table
- SNMP Configuration
- Ping Test
- Restore to Factory Defaults
- Reboot Switch
- Upload/Download Configuration
- Download Text Readable Configuration/Status File
- Update Software
- Support
- 3. Troubleshooting
- Index
- Back Cover
2-32
Using the ProCurve Web Browser Interface
Web Configuration
Using the ProCurve Web
Browser Interface
SNMP Configuration
This page allows you to configure the Simple Network Management Protocol
(SNMP). The SNMP agent permits READ ONLY access to the switch. Any
system in the network using management software can be used to discover
the switch. You can set the following options:
Field Attributes
• SNMP Enabled – Enables or disables SNMP. (Default: Enabled)
• Read Community – Community string for read access to the SNMP
protocol.
Web – Click SNMP, Configuration.
Ping Test
This operation allows you to test the network connections by sending an
Internet Control Message Protocol (ICMP) echo request packet from the
switch to other devices on the network. The page will display the results of
the operation.
Field Attributes
Ping Parameters
• Target IP Address – The IP address of the device to ping on the
network.
• Count – Number of packets to send. (Default: 1)
• Time Out (in secs) – Number of seconds to wait for a response.
(Default: 1)