- HP Network Switch User Manual
Table Of Contents
- ProCurve Switch 1700-8 and 1700-24 Management and Configuration Guide
- Title Page
- Copyright and Disclaimer Notices
- Contents
- 1. Getting Started
- 2. Using the ProCurve Web Browser Interface
- Overview
- Navigating the Web Browser Interface
- Web Configuration
- Displaying System Information
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Rate Limits
- Port Configuration
- Port Mirroring
- Showing Port Statistics
- Trunk Membership
- Trunk Configuration
- LACP Settings
- LACP Status
- VLAN Setup
- VLAN Port Config
- LLDP Configuration
- LLDP Neighbor Table
- SNMP Configuration
- Ping Test
- Restore to Factory Defaults
- Reboot Switch
- Upload/Download Configuration
- Download Text Readable Configuration/Status File
- Update Software
- Support
- 3. Troubleshooting
- Index
- Back Cover
2-29
Using the ProCurve Web Browser Interface
Web Configuration
Using the ProCurve Web
Browser Interface
LLDP Configuration
This page allows you to configure the Link Layer Discovery Protocol (LLDP)
configuration. LLDP allows devices on the network to share information about
themselves for the reasons of simplified troubleshooting, enhanced network
management, and maintaining an accurate network topology. LLDP-capable
devices periodically transmit information in messages called Type Length
Value (TLV) fields to neighbor devices.
Field Attributes
LLDP State
• Port – The port number.
• State – You can choose to disable or enable LLDP for each port.
Enabling LLDP will allow the port to receive and transmit TLVs.