- HP Network Switch User Manual
Table Of Contents
- ProCurve Switch 1700-8 and 1700-24 Management and Configuration Guide
- Title Page
- Copyright and Disclaimer Notices
- Contents
- 1. Getting Started
- 2. Using the ProCurve Web Browser Interface
- Overview
- Navigating the Web Browser Interface
- Web Configuration
- Displaying System Information
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Rate Limits
- Port Configuration
- Port Mirroring
- Showing Port Statistics
- Trunk Membership
- Trunk Configuration
- LACP Settings
- LACP Status
- VLAN Setup
- VLAN Port Config
- LLDP Configuration
- LLDP Neighbor Table
- SNMP Configuration
- Ping Test
- Restore to Factory Defaults
- Reboot Switch
- Upload/Download Configuration
- Download Text Readable Configuration/Status File
- Update Software
- Support
- 3. Troubleshooting
- Index
- Back Cover
2-25
Using the ProCurve Web Browser Interface
Web Configuration
Using the ProCurve Web
Browser Interface
Modifying a VLAN
1. Use the VLAN Setup page to modify a VLAN. Under the VLAN List section,
click on the radio button of the VLAN you would like to modify.
2. Click MODIFY.
3. Select the ports to be added to or removed from this VLAN.
4. Click APPLY.
Deleting a VLAN
1. Use the VLAN Setup page to delete a VLAN. Under the VLAN List section,
click on the radio button of the VLAN you would like to delete.
2. Click DELETE.
Note Before deleting a VLAN, make sure that all the ports in this VLAN are also a
member of another VLAN. Otherwise, the port will not be a member of any
VLAN.
Field Attributes
Add VLAN
• VLAN ID – Input a VLAN ID and click APPLY to create a new VLAN.
VLAN List
• VLAN List – The list of up to 64 VLANs. You can modify or delete
these VLANs.
Web – Click VLANS, VLAN Setup.