- HP Network Switch User Manual
Table Of Contents
- ProCurve Switch 1700-8 and 1700-24 Management and Configuration Guide
- Title Page
- Copyright and Disclaimer Notices
- Contents
- 1. Getting Started
- 2. Using the ProCurve Web Browser Interface
- Overview
- Navigating the Web Browser Interface
- Web Configuration
- Displaying System Information
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Rate Limits
- Port Configuration
- Port Mirroring
- Showing Port Statistics
- Trunk Membership
- Trunk Configuration
- LACP Settings
- LACP Status
- VLAN Setup
- VLAN Port Config
- LLDP Configuration
- LLDP Neighbor Table
- SNMP Configuration
- Ping Test
- Restore to Factory Defaults
- Reboot Switch
- Upload/Download Configuration
- Download Text Readable Configuration/Status File
- Update Software
- Support
- 3. Troubleshooting
- Index
- Back Cover
2-12
Using the ProCurve Web Browser Interface
Web Configuration
Using the ProCurve Web
Browser Interface
Port Configuration
You can use the Port Configuration page to manually set the speed, duplex
mode, and flow control. You can enable jumbo frames to support data packets
9000 bytes in size.
Field Attributes
• Enable Jumbo Frames – Click box to enable jumbo frames.
•Port – The port number.
• Speed/Duplex – Allows you to manually set the port speed and
duplex mode.
• Flow Control – Allows flow control to be enabled or disabled. When
the box is checked, flow control is enabled.
• Trunk – Indicates if a port is a member of a trunk.
Web – Click Ports, Configuration.
Note Ports within a trunk cannot be configured individually. However, you can use
the Trunk Configuration page to manually set the same speed, duplex mode,
and flow control for every port in a trunk.