- HP Network Switch User Manual
Table Of Contents
- ProCurve Switch 1700-8 and 1700-24 Management and Configuration Guide
- Title Page
- Copyright and Disclaimer Notices
- Contents
- 1. Getting Started
- 2. Using the ProCurve Web Browser Interface
- Overview
- Navigating the Web Browser Interface
- Web Configuration
- Displaying System Information
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Rate Limits
- Port Configuration
- Port Mirroring
- Showing Port Statistics
- Trunk Membership
- Trunk Configuration
- LACP Settings
- LACP Status
- VLAN Setup
- VLAN Port Config
- LLDP Configuration
- LLDP Neighbor Table
- SNMP Configuration
- Ping Test
- Restore to Factory Defaults
- Reboot Switch
- Upload/Download Configuration
- Download Text Readable Configuration/Status File
- Update Software
- Support
- 3. Troubleshooting
- Index
- Back Cover
2-9
Using the ProCurve Web Browser Interface
Web Configuration
Using the ProCurve Web
Browser Interface
• Subnet Mask – This mask identifies the host address bits used for
routing to specific subnets. (Default: 255.255.255.0)
• Gateway IP Address – IP address of the gateway router between
this device and management stations that exist on other network
segments. (Default: 0.0.0.0)
• Management VLAN – ID of the configured VLAN (1-4093, no leading
zeroes). By default, all ports on the switch are members of VLAN 1.
However, the management station can be attached to a port belonging
to any VLAN, as long as that VLAN has been assigned an IP address.
Note Be sure to keep a record of the switch's IP address. If you cannot remember
the switch’s IP address, you can restore the original settings by following the
procedure described in the “Troubleshooting” section.
If you change the switch IP address, you must close the Web interface and
start a new session using the new IP address.
Web – Click System, IP Address. Enter the IP address, subnet mask, gateway,
and select the Management VLAN, then click APPLY.