User Manual
Table Of Contents
- Getting started
- Important safety information
- More HP resources
- Getting to know your monitor
- Setting up the monitor
- Using the monitor
- Downloading software and utilities
- The Information file
- The Image Color Matching file
- Enabling G-SYNC compatibility (select products only)
- Using the OSD menu
- Using the OSD function buttons
- Reassigning the function buttons
- Camera
- Changing the Power Mode setting (select products only)
- Using Auto-Sleep Mode (select products only)
- Setting up Windows Hello facial recognition
- Using PiP and PbP (select products only)
- Adjusting blue light output (select products only)
- Using low blue light mode (select products only)
- Support and troubleshooting
- Maintaining the monitor
- Technical specifications
- Accessibility
- Index
5. Slide the stand out of the recess.
Attaching the monitor head to a mounting device
You might need additional tools such as a screwdriver (purchased separately) when you attach a mounting
device. To avoid damage to your monitor, follow these instructions.
1. Remove the four screws from the VESA holes located on the rear of the monitor head.
2. To attach the monitor head to a swing arm or other mounting device, insert four mounting screws
through the holes on the mounting device and into the VESA screw holes on the back of the monitor
head.
IMPORTANT: If these instructions do not apply to your device, then follow the mounting device
manufacturer’s instructions when mounting the monitor to a wall or swing arm.
Attaching the monitor head to a mounting device
9