User's Guide

3-32
Converting 2.6-Gb-Drive Jukeboxes to 5.2-Gb-Drive Jukeboxes
Converting From Jukeboxes Using 2.6-Gbyte Drives to Jukeboxes
Using 5.2-GByte Drives
Figure 3-24 Installing an EMI Gasket on the Bottom of the Right-Side Panels
6. Remove the adhesive strip from an EMI strip and attach it to the bottom edge of
the top and middle right side access panels as shown in Figure 3-24.
Note the orientation of the EMI strip shown in the inset on the figure.
7. Go to Chapter 4, “Checking/Downloading Firmware.”
Step 8: Install the Slot/Drive Map
Place the replacement drive map label over the previous label.
The drive map label is located on the inside of the left middle access panel (see
Figure 3-1).