User's Guide

3-30
Converting 2.6-Gb-Drive Jukeboxes to 5.2-Gb-Drive Jukeboxes
Converting From Jukeboxes Using 2.6-Gbyte Drives to Jukeboxes
Using 5.2-GByte Drives
1. Place the RFI clamp on the front panel cable as shown by #1 on Figure 3-22.
Remove the adhesive covering on the back of the RFI clamp and stick the back
of the clamp against the chassis as shown. You will have to push the GPIO cable
(#2) to the right a small amount to make room for the clamp to lie flat against the
chassis.
NOTE In the next step, you have either one or two RFI clamps depending on whether the
jukebox you are converting has one or two interposer PCAs. The step is described as
if you have two interposer PCAs.
2. Unstick the RFI clamps at location #3 and remove them from the SCSI cables.
Use the RFI clamps from the kit. Slide the clamps up on the SCSI cable until the
clamps are as close to the bottom of the lower interposer PCA as you can get
then. Restick the clamp on the bottom SCSI cable to the chassis and stick the
clamp to the top SCSI cable to the top of the first clamp.
3. When installing a lower interposer PCA, attach the second SCSI cable clamp to
the top of the clamp described in Step 2.
4. Place the thin, flat, cable clamps the six locations shown by #5 on Figure 3-22.
The goal of the cable clamps is to hold the cable bundles as flat and as close to
the chassis wall as possible to minimize RFI.