User's Guide

3-27
Converting 2.6-Gb-Drive Jukeboxes to 5.2-Gb-Drive Jukeboxes
Converting From Jukeboxes Using 2.6-Gbyte Drives to Jukeboxes
Using 5.2-GByte Drives
3. Connect the cables as shown in Figure 3-20.
• #1 - drive interface cable
• #2 - power cables (two connectors)
• #3 - SCSI cables (top cable in the diagram is the one just installed)
CAUTION Take care that you do not pinch the SCSI cables on the edge of the SCSI assembly
enclosure as you mount the assembly on the side of the chassis in the next step.
4. Remount the SCSI interface assembly on the chassis with four T-20 screws.
5. Attach the SCSI interface assembly label for two interface PCAs (see Figure
3-21)
Figure 3-21 Attaching SCSI Interface Label
6. Remount the interface module on the side of the chassis with four T-20 screws.