User's Guide

3-22
Converting 2.6-Gb-Drive Jukeboxes to 5.2-Gb-Drive Jukeboxes
Converting From Jukeboxes Using 2.6-Gbyte Drives to Jukeboxes
Using 5.2-GByte Drives
2. Remove the eight T-20 screws holding the PCA to the chassis (see arrows on
Figure 3-15).
3. Remove the upper interposer PCA (and lower interposer PCA if applicable).
4. Mount the replacement interposer PCAs from the kit and connect the cables (see
Figure 3-15).
Upper interposer PCA:
• #1 - SCSI cable
• #2 - vertical-path-clear transmitter
• #3 - GPIO cable
• #4 - mailslot sensor / motor cable
• #5 - control panel input/output
• #6 - vertical-path-clear receiver
• #7 - SCSI cable
• #8 - drive power input to interposer PCA
• #9 - configuration module (will do in “Step 4: Installing the Configuration
Module”)
• #10 - drive cables (will do in the following procedure “Step 3: Connect
Drive Cables to the Interposer PCAs”)
Lower interposer PCA:
• #1 - SCSI cable
• #2 - GPIO cable
• #3 - drive power input to interposer PCA
• #4 - drive cables (will do in the following procedure “Step 3: Connect
Drive Cables to the Interposer PCAs”)