User's Guide

3-8
Converting 2.6-Gb-Drive Jukeboxes to 5.2-Gb-Drive Jukeboxes
Converting From Jukeboxes Using 2.6-Gbyte Drives to Jukeboxes
Using 5.2-GByte Drives
Figure 3-5 Drive Cables
7. Use the drive cables from the kit and route the cables for two drives into the
enclosure as shown in Figure 3-5.
• #1 - drive power cables
• #2 - SCSI cable
• #3 - drive interface cables
8. Mount the cable clip on the rear of both drives as shown in #4 of Figure 3-5.
9. Slide the bottom drive into the enclosure far enough to connect a set of drive
cables to the drive as shown in #1, #2, and #3 on Figure 3-5.
As you connect the drive interface cable, slide the cable into the cable clip on the
rear of the drive.
10. Slide the top drive into the enclosure far enough to connect a set of drive cables
to the drive as shown in #1, #2, and #3 on Figure 3-5.
As you connect the drive interface cable, slide the cable into the cable clip on the
rear of the drive.
11. Insert the T-10 screws to mount the drives (see Figure 3-4).
Each drive uses four screws; two on each side.