User's Guide

3-6
Converting 2.6-Gb-Drive Jukeboxes to 5.2-Gb-Drive Jukeboxes
Converting From Jukeboxes Using 2.6-Gbyte Drives to Jukeboxes
Using 5.2-GByte Drives
1. Disconnect all drive cables for the drive enclosures you are converting (Figure
3-3 uses drives at position #1 as an example).
2. Remove the T-20 screws from each side of the drive enclosure. Remove the
drive enclosure from the chassis (see #5 on Figure 3-3).
Figure 3-3 Removing the Cables and Screws
3. Remove the four T-10 screws holding the top and bottom access plates on the
drive enclosure (see #1 and #2 in Figure 3-4). Remove the plates.
4. Remove the four T-10 screws that hold the drives in the drive enclosure and
slide the drive forward a small amount to give you room to remove the cables.
(#3 screws on Figure 3-4 hold the upper drive, #4 screws hold the lower drive.)