User's Guide

2-7
Upgrading Drives and Capacity in 5.2-Gb Drive Jukeboxes
Upgrading Drives (C1154J/K/L, C1158J/K/L Kits)
4. Mount the cable clip on the rear of both drives as shown in #4 of Figure 2-4.
5. Slide the bottom drive into the enclosure far enough to connect a set of drive
cables to the drive as shown in #1, #2, and #3 on Figure 2-4.
As you connect the drive interface cable, slide the cable into the cable clip on the
rear of the drive.
6. Slide the top drive into the enclosure far enough to connect a set of drive cables
to the drive as shown in #1, #2, and #3 on Figure 2-4.
As you connect the drive interface cable, slide the cable into the cable clip on the
rear of the drive.
7. Insert the T-10 screws to mount the drives (see screws labeled #3 and #4 on
Figure 2-5).
Each drive uses four screws; two on each side.
Figure 2-5 Mounting the Drives Into the Drive Enclosure
8. Remount the top and bottom covers on the enclosure (see #1 and #2 on Figure
2-5)