System information

4.
Lift the board as far as the cables allow, and then disconnect the two cables from the board (3).
NOTE: Be careful not to damage the cables when disconnecting them from the board. Do not
pull on the wires.
Figure 6-45 Removing the power button board
5. Remove the board from the computer.
To remove the power button board cable:
1. Prepare the computer for disassembly (see
Preparing to Disassemble the Computer on page 29).
2. Remove the rear cover (see
Rear Cover on page 30).
3. Disconnect the cable from the power button board (1) and the system board (2).
64 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis