user manual

Overall WEBES Release Notes
1.6 WEBES Known Issues
Rev. 9/8/06
Web-Based Enterprise Services Release Notes 1–21
Workaround
• Define system PATH variable with some value (not null) before installing.
• Manually add WCCProxy path to PATH after installation.
1.6.2.14 Windows Itanium Installation may interrupt if PATH
variable is 256 characters or longer
In case of Windows Itatium, if the system PATH variable is 256 characters or longer then
during the WCCProxy installation an error dialog box pops up “Failed to get PATH”. The
reason behind is that, post installation the PATH variables only contains WEBES
path.WCCProxy path is not added. As a result of this, WCCProxy commands like
“wccproxy status” do not work.
Workaround:
• Remove junk entries from PATH.
• Manually add WCCProxy path to PATH after installation.
1.6.3 Linux WEBES Issues
These issues apply to WEBES on Red Hat Linux:
1.6.3.1 Director May Require Restart
If the system is configured to restart in graphical user interface mode (run level 5), the desta
Director may not always automatically restart. For run level 5, always restart the Director
manually after any type of system restart:
# desta start
Linux systems that restart in command-line mode (run level 3) correctly restart the desta
Director automatically whenever the system restarts.
1.6.3.2 Segmentation Fault Error Message
If you had installed an ISEE Client containing WCCProxy 1.0, when installing WEBES you
may see the following error message when the WCCProxy is stopped (so that it can be
replaced with the newer version bundled in WEBES):
Stopping the WCCProxy.
/usr/sbin/wccproxy: line 122: 10052 Segmentation fault