user manual

ENWW 10 Problem solving 295
DISK DEVICE
FAILURE
The EIO hard disk had a critical failure
and can no longer be used.
1 Turn off the MFP.
2 Remove and reinstall the hard disk.
3 Turn on the MFP.
4 If the message continues, replace
the disk with a new EIO hard disk.
DISK FILE
OPERATION FAILED
The requested operation could not be
performed. You might have attempted
an illegal operation, such as trying to
download a file to a nonexistent
directory.
Check the file name and try the
operation again.
DISK FILE
SYSTEM IS FULL
The disk file system has reached
maximum capacity.
Delete files from the EIO hard disk and
then try again. HP Web Jetadmin can be
used to delete files and fonts. Use the
control panel to delete stored jobs that
are no longer needed.
DISK IS
WRITE PROTECTED
The disk device is protected, and no
new files can be written to it.
Fonts and forms cannot be stored on the
disk when the disk is write-protected.
Use the Windows-based HP Web
Jetadmin or the Macintosh-based
HP LaserJet Utility to remove the write
protection from the disk.
DISK NOT INITIALIZED The disk file system is not initialized. Initialize the disk file system by using
HP Web Jetadmin.
DUPLEXER ERROR
REMOVE DUPLEXER
INSTALL DUPLEXER WITH
POWER OFF
The duplexer is not functioning correctly. 1 Turn off the MFP.
2 Remove the duplexer.
3 Check the duplexer and duplexer
cavity for residual jammed media.
4 Reinstall the duxpler and make sure
that it is reseated securely.
5 Turn on the MFP.
E-MAIL GATEWAY DID NOT
ACCEPT THE JOB BECAUSE
THE ATTACHMENT WAS TOO
LARGE
The server rejected an e-mail. Make sure that you are typing the
correct e-mail address.
E-MAIL GATEWAY DID NOT
RESPOND
The connection to the e-mail server has
timed out.
Make sure that the e-mail server
address is correct.
EIO X The EIO hard disk in slot X is initializing. No action is necessary.
EIO DISK FILE OPERATION
FAILED
The requested operation could not be
performed. You might have attempted
an illegal operation, such as trying to
download a file to a nonexistent
directory.
Check the file name and try the
operation again.
EIO DISK NOT FUNCTIONAL The EIO hard disk in slot X is not
working correctly.
1 Turn off the MFP.
2 Remove the EIO hard disk from the
slot that is indicated by X.
3 Reinstall the EIO hard disk.
4 Turn on the MFP.
5 If the message continues, replace
the disk with a new EIO hard disk.
Message Description or explanation Recommended action