user manual

222 Managing supplies ENWW

Replacing the image transfer kit

Use this procedure to install the image transfer kit.

Note

Remove your jewelry, which can snag on parts inside the MFP.

1 Replace the image transfer kit when REPLACE TRANSFER KIT

appears on the control-panel display.

2 If tray 1 is open, remove any paper that is loaded in the tray,

and then close the tray.

3 Open the front doors of the MFP, and then swing the large

green lever down.

4 Slide the 2,000-sheet side input tray (tray 4) away from the

MFP.

5 Open the upper door on the right side of the MFP.

Note

Residual toner might be on the transfer belt; before removing the

belt, prepare a paper-covered surface on which to place it. If toner

gets on your clothing, wipe it off with a dry cloth and wash the

clothing in cold water. Hot water sets toner into fabric.

6 Pull the blue handle on the bottom of the belt until the belt

stops.

WARNING!

The transfer belt is heavy.