user manual

Configuring the Fibre Channel ports
Configure the disk array Fibre Channel ports by using Remote Web Console (shown) , Command View
(XP arrays only), or Command View XP Advanced Edition. Select the settings for each port based on
your storage area network topology. Use switch zoning if you connect different types of hosts to the
array through the same switch.
Fibre address
In fabr
ic environments, the port addresses are assigned automatically. In arbitrated loop environments,
set th
e port addresses by selecting a unique arbitrated loop physical address (AL-PA) or loop ID for each
port.
For specificvalues,refertotheHP StorageWorks LUN Configuration and Security Manager XP
User Guide applicable to your array.
HP StorageWorks Disk Array XP operating system configuration guide: Windows 2000/2003
15